Agustus 21
Venting Sealed Section
Every sealed section of a fabrication must be vented for reasons of safety and to allow access and drainage of molten zinc. Holes diagonally opposite each other should be as close as possible to the sealed end.
Recent Posts
- Overlapping Surfaces21 August 2018.
- Venting Sealed Section21 August 2018.
- Structural Hollow Holes21 August 2018.
- Angle Bracings Assembly22 August 2018.
- Cropping The Corners21 August 2018.
- Stiffeners & Gussets Cropping16 August 2018.